• • 200 loads per hour

• • 18″, 24″, 36″, 48″ or 60″ diameter ring
  • Other ring sizes available
  • Machine dimensions depending on ring size

• • 230 V / 3 ph /60Hz 20A

• • 3 cfm @80 psi

• • Allen Bradley Micrologix 1200 PLC
  • Automatic cut & clamp system
  • 24V control system
  • Top hold down activation photoeyes (if applicable)
  • Start / stop push button
  • Auto/Manual/Continuous mode
  • Current overload protection
  • NEMA 4/12 control cabinet with quick disconnect
  • Power on/off switch and indicator pilot light
  • Large emergency stop (push / pull type)
  • End wraps selectors (1-2-3)
  • Push button to activate film cut & clamp
  • Foot pedal ring activation or load release
  • UL approved components and UL508A control pane

• • Communication package with entrance & exit conveyor, cut & clamp sequence occurs upon clearance of the exit photoeye OR
  • Load release by foot pedal and powered conveyor, cut & clamp sequence occurs upon clearance of the exit photoeye
  • When load is fed by conveyors controlled by Wulftec, machine comes with a push button for banding mode

Manual Push Through Operation

• • 5″ to 10″ film carriage. (Film core diameter 3″)
  • Manual film tension adjustment directly on carriage
  • Quick and easy film roll change
  • Can be used with pre-stretched film for more cost saving

Film Tail Treatment

• • All structural steel design
  • Fully guarded frame
  • Electric interlocked access doo

Drive System

• • RPM based on ring size (80 RPM on a 36” ring)
  • AC motor with variable frequency drive
  • Aluminum ring driven by a flat belt allowing higher speeds
  • Maintenance free vertical polyurethane guiding wheels with sealed bearings
  • Electronic soft start/stop
  • Positive ring alignment controlled by proximity sensor
  • Electric brake system

• • 1 E-Stop mushroom type push button on control panel (Additional E-Stops are available upon request*)
  • Wrapping zone enclosed with an electronically interlocked access door

• • A large variety of gravity and powered conveyors are available. (Chains, belts, v-belts, roller, etc.)

Technical Information

• • The machine is provided with a manual including electro/mechanical schematics and drawings, troubleshooting guide and installation instructions